KILZ® Masonry, Stucco & Brick Flat Paint

Preparation^†

The following steps and products are required.

• Allow new stucco and masonry to cure for 30 days before painting.

• Remove all loose, peeling paint. Power wash to remove chalk. Remove dirt, grease and mildew stains with KILZ Concrete & Masonry Cleaner & Degreaser.

• On galvanized metal, use a diluted solution of KILZ Concrete & Masonry Cleaner & Etcher to prepare the surface. Rinse thoroughly and allow a minimum of 24 hours to dry.

• Cracks and gaps wider than 1/16" should be routed open, dusted and patched with a quality patching compound. Use an acrylic caulk around windows, doors and trim. Scuff sand glossy surfaces.

• If chalk remains on the surface, prime with a KILZ Premium Primer. Prime all patched areas as well as adjacent wood and metal surfaces. If previously sealed or coated, check manufacturer’s specifications before painting.

Application

• DO NOT DILUTE. Intermix all cans of same product to ensure color uniformity. Stir paint before and occasionally during application.

• For best results, apply when air and surface temperatures are between 50-90°F. Do not use if rain or heavy dew is expected within 24 hours.

• Apply using a high quality 3/4"-1" nap roller (rough surfaces) or 3/8"-1/2" nap roller (smooth surfaces), nylon/polyester brush or airless sprayer (.015"-.021" spray tip, 60 mesh filter). Apply a second coat, if necessary.

• Maintain a wet edge to avoid lap marks. Do not re-spread or re-work paint.

• COVERAGE: Rough surfaces: 250-300 sq. ft; Smooth surface 400 sq. ft.

Dry Time

Dries to touch in 2-3 hours; 4 hours to recoat. Longer dry time required in cooler temperatures and higher humidity. After two weeks, cured paint film may be cleaned with a mild, non-abrasive liquid detergent.

Clean-Up & Disposal

• Clean equipment and paint spatters with warm, soapy water. If spilled, contain material and remove with an inert absorbent. Dispose of contaminated absorbent, container and unused product in accordance with all current governmental regulations.

• Do not dispose of this product down a drain. For recycling or disposal information contact your local household refuse collection service.

Cautions / Limitations

• Protect from freezing.

• Do not use on floors.

• For best results, apply at temperatures between 40°F-90°F. Temperatures above 90°F may affect the application such as drying too fast. Avoid painting in direct sun. NOTE: If the surface is hot to the touch it should be considered too hot to apply this coating.

• Avoid heavy traffic for 24 hours.

• Allow two weeks before washing or cleaning for full cure.

• Shelf life under normal conditions is two years unopened.

*Limited Warranty

Masterchem Industries LLC warrants to you, the original residential consumer purchaser, the performance of this product as described on this label for 20 years from the date of purchase. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT PROPERLY APPLIED TO A PROPERLY PREPARED, VERTICAL SURFACE OR CARED FOR IN ACCORDANCE WITH THE LABEL DIRECTIONS.  This warranty is not transferable. If this product is found not to perform as specified on the label during the warranty period, Masterchem Industries LLC will, at its option and upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or refund the original purchase price of this product to you. This warranty excludes (1) labor and costs of labor for the application or removal of any product, and (2) any incidental or consequential damages, whether based on breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state.  Note to residents of the State of New Jersey: The provisions of this warranty, including its limitations, are intended to apply to the fullest extent permitted by the laws of the State of New Jersey. For warranty service, call: 1-866-774-6371, or email: techservice@mastechem.com. Masterchem Industries LLC reserves the right to inspect any and all application of the product prior to processing your claim made under this warranty.

General Information

IMPORTANT! DO NOT OPEN CAN WITHOUT READING INSTRUCTIONS

^†Warning!

If you scrape sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator tor to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm.

Warning! Irritant!

HARMFUL IF SWALLOWED. CONTAINS: ETHYLENE GLYCOL. MAY CAUSE EYE, NOSE AND THROAT IRRITATION.AVOID CONTACT WITH SKIN AND EYES AND AVOID BREATHING OF VAPORS AND SPRAY MIST. WEAR EYE PROTECTION AND PROTECTIVE CLOTHING. USE ONLY WITH ADEQUATE VENTILATION. To avoid breathing vapors and spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air and use a properly fitted respirator (NIOSH approved for zorganic vapor with P Series particulate prefilter). Obtain professional advice before using. A dust mask does not provide protection against vapors. Avoid contact with eyes and skin. Wash thoroughly after handling. Close container after each use.

First Aid

• If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
• In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention.
• For skin, wash thoroughly with soap and water.
• If swallowed, get medical attention immediately.

Caution

• KEEP OUT OF REACH OF CHILDREN.
• DO NOT TAKE INTERNALLY.

• Base

  Deep Base & White Base

• Int/Ext

  Int/Ext

• Color

  N/A

• Coverage Rate

  250-400 sq. ft./Gal.

• Coverage - Low

  250 sq. ft.

• Mils Wet

  6.4

• Mils Dry

  2

• Coverage High

  400 sq. ft.

• Mils Wet

  4

• Mils Dry

  1.3

• Viscosity

  95 - 105 KU

• VOC

  50 g/L

• Volume Solids

  30.2 %

• Weight Solids

  43.8 %

• Flashpoint

  N/A